There is quite a bit of work involved
The first two are chemical cleaning solutions that will remove soaps and penstock oils from the surface of the tub and prepare it for the primer.Of course, youll want to make sure that you work safely. This topcoat will take about 48-72 hours to completely cure. As you can see, there is quite a bit of work involved, but bathtub refinishing the DIY way can be a cost effective way to dramatically update your bathroom! Most kits require you to clean the tub with the first solution, scrubbing the tub with sandpaper, usually 220 or 240 grit.Next, youll apply the base coat to the tub.Bathtub not looking as good as it should? Are you stuck with one of those outdated colors of the 1970s?
With a few simple preparations and a lot of patience, you can learn how to refinish a bathtub and save yourself the hassle of buying and installing a new tub. The next job for the bathtub refinishing process is to mask the area around the bathtub that will not be refinished. Once the tub is thoroughly scrubbed, rinse away any residue.
The second cleaning solution is applied next, usually with a specially designed cleaning pad that also scores, or roughs, the surface of the tub. After this, repair any damage to the tubs surface and drain area with putty and allow to dry. Also, protect yourself with a ventilator, safety goggles and gloves. After about 30 minutes, sand the repaired areas smooth with a fine grit sandpaper, clean with the primer reducer and dry. Carefully apply the reducer with paper towels. Following the manufacturers directions, mix the primers components exactly and use a spray gun to apply to the bathtub. Carefully apply tape and paper to the areas around the tub, burnishing any tape with your fingernail or a credit card to assure a good seal. Since bathtub refinishing involves chemicals, some of which are toxic, make sure that you ventilate the area well before beginning. Once protected, gather your supplies and get going! Give your tub a cursory cleaning and remove any loose caulking and gaskets.
The third solution in the kit is a primer reducer, a solvent that removes any remaining residue and prepares the surface for the primer.Mix the paint for the China Butterfly Check Valves Manufacturers topcoat following manufacturers instructions. Remember to wear your respirator for this part of the process, and make sure that your area is properly ventilated. This second step removes any remaining oil or soap and also provides grab for the primer. Rinse the tub again and dry with an old towel or paper towels.Most bathtub refinishing kits come with several chemicals. Allow the primer to dry for at least 30 minutes before applying the top coat
